Ojmar INFOTERMINAL, Инструкция по сборке

Страница: 2 / 4

1. INFOTERMINAL INSTALLATION
2. INFOTERMINAL CONNECTION
3. INFOTERMINAL PLACEMENT
4. ADJUSTMENT OF INFOTERMINAL
To install the Infoterminal, 4 holes must be made in the wall to fasten the
support and a hole to pass through and house the alignment and network
cable. Install the bracket after drilling the holes in the wall. (See figure 2)
After putting up the bracket, pass the RJ-45 power and Ethernet cable
through the central hole and connect it to the Infoterminal at the back.
After connecting the power and network cables to the Infoterminal, put it onto
the bracket. To do this, slide it from top to bottom, inserting the 4 bracket
plates into the Infoterminal’s slots and putting the cables inside the wall cavity.
Finally, adjust the Infoterminal by tightening the two screws on its bottom.
1. ASSEMBLY INSTRUCTIONS