K
AP45-M
12
■
Turbo mode
When the indoor air was polluted, the air purifier will
clean the polluted air in the strong mode for a short
period of time.
• Press the
(
turbo)
button to perform the turbo
operation. The
(
turbo)
lamp will light up.
Light up
• It will perform the turbo operation for about 10
minutes.
• To end the turbo operation, press the
(
turbo)
button or
(
operation mode)
button.
• The operation will start with the set mode before
the turbo operation.
※
Opening the flap of air outlet during the turbo
operation is recommended.
■
To stop the operation
• Press the
(
operation OFF/ON) button during
operation, the operation will stop with beep sounds.
■
Change the brightness
• Press the
(
change brightness)
button to
change the brightness of the backlight. Every time
the button is pressed, the backlight’s brightness will
be changed as below.
→
100%→50%→10%→Light off
※
Stop the operation to turn off the backlight.
Operation instructions
Press operation OFF/ON button
• The operation will start with the set mode before
stopping operation.
• After plugging out the power code or undergoing
power failure, turn on the power to start the
operation in automatic operation mode.
Caution
●
As the sensor has high
sensitivity, if an ultrasonic
humidifier or a spray is used
nearby, the sensor may react,
without visible mists.
Select the operation mode
• Press the
(
operation mode) button to change
the mode.
Automatic operation
Selecting the
(
automatic operation)
will
automatically change the air flow volume based on
the density that the sensor detects.
Silent
, Normal
, Strong
Selecting
(
silent
, normal
, strong )
will perform the continuous operation regardless of
the sensor.