Set up and Checkout
2-1
6600-0361-000
08/10/02
2-1
CAUTION
w
To avoid damage to equipment, install
bulb before powering unit.
Mounting the unit
1.
Using the hex key provided with the unit, loosen the two
mounting screws on the side of the mounting bracket
2.
Position the light source unit on the accessory dovetail rail.
3.
Secure the unit in place by tightening the two mounting
screws with the hex key.
Pre-use Check Out Procedure
1.
Examine the power cord, gooseneck, and light source unit
for obvious signs of damage.
2.
Check that the light source unit is securely attached to the
accessory dovetail rail.
3.
Move the gooseneck back and forth and up and down and
verify that it moves freely and stays in position.
4.
Connect the power cord to an appropriate power source.
5.
Select “|” on the power switch to turn the power on. The
power LED indicator will light.
Note: Immediately after turning the unit on, it takes several
seconds for the light to be emitted from the lens head. If
the light does not come on, switch off the unit, wait about
ten seconds and switch it back on.
6.
Position the lens head so that the spot is on the center of
the bed.
1
2
3
1.
Mounting bracket
2.
Mounting screws
3.
Dove tail rail
CI.38.013
