OHM
（
ChongQing
）
Electronic Technology CO.,LTD.
Tel: 023-68151154 Fax: 023-68151154-803 Service:400-920-9120
Ver.: 2016.01.1.0.3 Operating Manual for TCS-C Page 1 of 28
1
、
Safety instructions
¾
Read through these operating -manual carefully before working with the radio control system.
¾
As an integral part of the radio control system, the operating instructions shall be always kept
by -responsible personnel.
¾
The term “machine” used in the operating manual refers to various equipment controlled by
the radio control system in general;
1.1 Intended Use
¾
The radio control system is used to control machines and for data transfer. Observe the job
safety and accident prevention regulations applicable to each application.
¾
The use also includes reading the operating instructions and adhering to all safety
information contained therein.
¾
The radio control system must not be used in areas where there is a risk of explosion, nor for
the control of machines used to convey persons, unless it is explicitly approved by the
manufacturer for these uses.
¾
Modifications to the radio control system must only be carried out by specialist personnel who
have been trained and authorized by OHM. All modifications must be documented at the
factory in the form of documents.
¾
The safety devices of radio control system must not be modified, removed or bypassed. It is
absolutely forbidden to make modifications to any part of complete emergency stop link of the
radio control system.
1.2 Safety instructions for installation and operation
¾
The electrical connection for the receiver can only made by professional electricians. It shall
be connected as per bundled output wire diagram.
¾
The receiver can only be opened by trained personnel. Live parts inside the system may have
life-threatening voltage. Make sure to cut off the power supply to the machine before opening.
¾
Note that the presence of persons in the danger zone-in particular beneath the load of
cranes-is prohibited in every instance.
¾
Select a safe operation location for the radio control system, from which you have a good and
complete view of the working movements of the machine, the load movements and the
