OHM
（
ChongQing
）
Electronic Technology CO.,LTD.
Tel: 023-68151154 Fax: 023-68151154-803 Service:400-920-9120
Ver.: 2016.01.1.0.3 Operating Manual for TCS-C Page 17 of 28
4
、
Transmitter operation
4.1 Transmitter installation
¾
Transmitter battery installation: Check the battery level prior to installation to avoid abnormal
operation caused by insufficient battery voltage; pay attention to the direction of the battery
during installation and ensure reliable battery installation; when the transmitter is not used for
a long time, take out the battery.
¾
Transmitter placement: The transmitter shall be put at a safe and striking place to avoid
damages caused by falling.
4.2 Transmitter startup
¾
Place a fully charged OHM battery pack into battery compartment.
¾
Pull out the emergency stop switch of the transmitter. long press ”Start” to make the green
light normally on; when the green light twinkles once per second, this indicates the machine
is normally started.
4.3 Transmitter shutdown
¾
Push the Emergency Push Buttonswitch of the transmitter and then the power indicator lamp
will be off and the transmitter will be shut down.
4.4 Table on transmitter indicator lamp status
4.4.1 Power indicator lamp
The green lamp twinkles once per second
The transmitter works fine.
The red lamp twinkles once per second
and is accompanied with sounds of the
buzzer.
The battery is over used.it needs be recharged.
(3.3V-3.5V)
The green and red lamps flash alternately
The Smart Card is not identified or lost.
The green and red lamps are always on
RF module is not identified.
4.4.2 Status indicator lamp
Determined according to system characteristics; for more information, see the bundled drawing.
