OHM CRED Mark 2 2-4, Руководство пользователя

Страница: 10 / 30

Gain
0.0dB Width
Freq
100Hz
EQ1
Out1
1.4Q
CHANNEL
PARAMETER
A B C
A parameter may be adjusted when it is displayed by turning one of the three-parameter knobs. Each
of the three-parameter knobs is associated with a zone on the display. Adjusting the leftmost
parameter knob will change the value of the parameter showing in the leftmost zone of the display
and so on. Turn a knob clockwise to increase the value of a parameter, or anti-clockwise to decrease
it. The knobs are velocity-sensitive so turning a knob rapidly will cause the action to 'accelerate', so
the value changes more rapidly.
Navigation
The DSP parameters are organised by channel. The currently selected channel is shown in the top left
hand corner of the display. You can navigate between the channels by pressing the channel buttons.
Pressing the channel buttons will scroll through the channels, utilities and back to the default screen.
When using a Preset that is stereo linked, the channel selection will reflect this. For example '1&4'
indicates outputs 1 and 4. When navigating onto an output channel, the usage of the output, as
define in the factory preset, will be shown briefly at the top of the screen.
Pressing the edit navigation buttons gives access to the various pages of parameters available for
each channel. The currently selected page is shown in the bottom left hand corner of the display, this
is omitted on some pages where the function is obvious. The screen shows up to three (normally
related) parameters for a given part of the processing functions on a given channel.
The edit buttons allow you to scroll, in either direction, through the different processing pages for a
given Channel. When you go past the last page, you will be returned to the default page.
The channel buttons allow you to scroll, in either direction, through the input and output channels,
whilst trying to maintain the currently viewed processing block. If the channel you scroll to does not
have the currently viewed processing block, the next one will be shown instead.
NB. When the unit powers-up, the settings will be the same as those when the unit was last switched
off.
Presets
The device contains a total of 45 user and . The user cannot overwrite the basic mono,
basic stereo or programs.
Factory Presets
Factory Preset
Preset Recall
To select an existing Preset, press the Recall Button so the indicator above it illuminates. Turn
parameter knob A until the required Preset number is shown on the display. Factory presets are
indicated by a box symbol appearing after the preset number. Press the Recall Button again to
activate the Preset. Pressing any other button will cancel the operation.
10