© Öhlins Racing AB. All rights reserved.
Any reprinting or unauthorized use without the
written permission of Öhlins Racing AB
is prohibited. Printed in Sweden.
Mounting Instruction TR 807_0 Issued 2008-06-09
This instruction and other documents
can be downloaded from
www.ohlins.com
Mounting Instructions
Kit Contents:
Part no. Pcs.
Shock absorber
TR 807
1
Öhlins Sticker
00192-01 2
Memo Notes Sticker 01180-01 1
Owner’s Manual
07241-02 1
Before installing this shock absorber,
check the contents of the kit listed
below. If anything is missing, please
contact your nearest Öhlins dealer.
SHOCK ABSORBER TR 807
for Triumph 1050 Speed Triple
During storage and transportation,
especially at high ambient temperature,
some of the oil and grease used
for assembling may leak and stain
the packaging. This is in no way
detrimental to the product, wipe off the
excessive oil/grease with a cloth.
Before installing this product, read the Öhlins Owner’s Manual!
Installing
a shock
absorbe
r that is n
ot
approved
by the v
ehicle m
anufactu
rer
may affe
ct the sta
bility of y
our vehic
le.
Installing
a shock
absorbe
r that is n
ot
approved
by the v
ehicle m
anufactu
rer
may affe
ct the sta
bility of y
our vehic
le.
Installing
a shock
absorbe
r that is n
ot
approved
by the v
ehicle m
anufactu
rer
may affe
ct the sta
bility of y
our vehic
le.
Installing
a shock
absorbe
r that is n
ot
approved
by the v
ehicle m
anufactu
rer
may affe
ct the sta
bility of y
our vehic
le.
Öhlins Racing AB, Box 722, S-194 27 Upplands Väsby, Sweden.
Phone +46 8 590 025 00 Fax +46 8 590 025 80
www.ohlins.com
with
set
-
up
data
Set-up Data
Shock absorber length 371.5 mm
Stroke
61.5 mm
Spring preload
12 mm
Compression damping 14 clicks
Rebound damping
16 clicks
Spring
01095-54
Free spring length
180 mm
(140N/mm)
WARNING!
The adjustable end eye/bracket must not be
threaded out more than that the groove is fully
visible beneath the lock nut. This is maximum
length. After adjusting, make sure that the lock
nut is tightened.
!
Length
We advise to remove the shock absorber
before adjusting the length. Use two
wrenches. Hold the upper nut with one
hand and at the same time loosen the
lock nut (lower nut). Turn the end eye/
bracket to the desired length.
1 turn = 1 mm length adjustment. Lock
the lock nut. Tightening torque: 40 Nm
4
4
ADjuSTMENTS
