3
MOUNTING INSTRUCTIONS
2.4 Fill oil
Öhlins front fork fluid (01309-xx).
2.5 Pump out all air
See the Owner’s manual chapter 2.1.
2.6 Set the oil level
See the Owner’s manual chapter 2.2.
Recommended level see Setup data.
2.7 Install the spring
See the Spring recommendation in this folder.
Install Pull up tool (01765-04) on top of the
shaft extension. Install the spring, with the
marking up, over the tool.
2.8
Install the guide sleeve over the tool.
2.9
Pull up the shaft assembly and at the same
time push down the guide sleeve. Insert a
19 mm wrench (04705-03).
2.10
Use a 3 mm Allen key to open the
compression/rebound adjusters fully.
Remove the Pull-up tool (01765-04) and mount
the top cap on the shaft extension. Use a
14 mm socket wrench. Tighten to 30 Nm.
Carefully remove the 19 mm wrench and make
sure that the guide sleeve is correctly inserted
in the preload socket.
Notee!
1
Ensure to install the cartridge top cap in the
correct fork leg.
2.11
Make sure that the fok leg is in a fully extended
position. Pull up the outer tube. Use Sleeve pin
tool (00797-08) to tighten the top cap to the
outer tube. Tighten to 10 Nm.
2.12
Set the compression, rebound and spring
preload adjusters according to Setup data in
this folder. See the Owner’s Manual chapter 4
for information about how to adjust.
2.4
2.6
2.9
2.7
2.8
2.11
2.10