2
1
Put the motorcycle on a work stand so that the
rear wheel barely touches the ground.
2
Remove seat, right and left side fairing.
3
Remove the coolant expansion reservoir
screws to gain access to the upper shock
absorber attachment screw if necessary.
4
Remove the shock absorbers front attachment
screw.
5
Remove the rear shock absorber attachment
screw at the shock-link and remove the original
shock absorber.
MOU TI G I STRUCTIO S
arninge!
⚠
We strongly recommend to let an Öhlins dealer
install this product.
arninge!
⚠
If you work with a lifted vehicle, make sure that it
is safely supported to prevent it from tipping over.
otee!
1
When you work with this product, see the
vehicle service manual for vehicle specific
procedures and important data.
otee!
1
Before you install this product clean the vehicle.
6
Install the Öhlins shock absorber with the
cylinder head gas valve up. Install the rear
shock absorber attachment screw first.
7
Install the front shock absorber attachment
screw and the linkage rods.
otee!
1
Lower the vehicle so that the suspension
is slightly compressed before you tighten
the screws.
Cautione!
✋
Make sure that you tighten all screws to the
correct torque and that nothing fouls or restricts
movement of the shock absorber/front fork/
steering damper when the suspension is fully
compressed or extended.
