OHAUS GT 210, Инструкции по применению и установке

Страница: 60 / 121

21
OPERATION
Percent Weighing Percent Weighing Percent Weighing Percent Weighing Percent Weighing
Percent Weighing is
enabled only enabled only enabled only enabled only enabled only
when
the Percent Function is selected under the
Setup menu. Refer to page 40. Percent
weighing permits you to place a reference
load on the balance, then view other loads
as a percentage of the reference. The load
you place on the platform as a reference
may be displayed as any percentage you
select from 5% to 100% (in 1% incre-
ments). One hundred percent does not
necessarily have to represent the reference load. Subsequent loads, displayed as a
percentage of the reference are limited only by the capacity of the balance. The
default setting is Reference 100%.
To perform percent weighing when in a weighing mode, use the following procedure:
1. .
2. Place an empty container on the pan (if one will be used).
3. . This is the current reference percentage.
NOTE NOTE NOTE NOTE NOTE: The reference percentage can be changed to any value from 5 to 100.
4. increments to .
NOTE NOTE
NOTE NOTE
NOTE: does not return to a lower number. Instead, it sends Set x%
command through the RS232 Interface, where x = 5 to 100.
5. When the selected reference value appears on the display, place the
reference load in the container (or directly on the platform if no container is
used).
6. , display indicates the reference load as
the percentage entered. The bar graph indicates the load relative to the
capacity of the balance.
7. Remove the reference load from the balance and replace it with another
load. The second load is displayed as a percentage of the reference.
8. to view alternate display in units.
9. To restart percent weighing at any time, .
10. to exit to a weighing mode.
EXAMPLE EXAMPLE
EXAMPLE EXAMPLE
EXAMPLE
A 10g reference load is set for 20%:
•
A subsequent load of 100 g will be
displayed as 200%.
•
A subsequent load of 200 g will be
displayed as 400%.