OHAUS Courier 7000, Инструкция по эксплуатации

Страница: 12 / 63

EN-8 Courier 7000
RS232 to PC
The RS232 is the alternative method of the connection.
1. Connect the RS232 cable to the terminal through the
mounting hole in the bracket.
RS232
2. Connect the other side of the RS232 cable to the PC.
(Typically labeled COM 1, COM A or IOIOI).
3. To supply power, you can use the USB cable and AC
adapter or the dry batteries (Refer to 2.3.1 Power
Supply Connection ).
NOTE :
Connections can also be made using the options for a 2nd RS232, Ethernet or WiFi/Bluetooth connection via
the Mini DIN connection. More details about each connection is found in the manuals for each option. Once an
option is connected to the scale, the menu will then show options for configuring the connection.
2.3.3 Direct Wall Mounting
The terminal may be mounted directly to a wall using two screws (not included).
1. Remove the cable ties on the bottom of the scale to
release the load cell cable.
Load cell cable
2. Loosen the 2 screws on the terminal mounting bracket
to remove the terminal.
3. Select appropriate size screws that fit into the holes at
the bottom of the terminal housing. See Figure A .
When mounting to a wall without a solid backing, use
appropriate anchoring hardware.
Figure A. Direct Wall Mount Arrangement
2.3.4 2nd Display Installation (available as option)
OHAUS offers a remote 2nd Display as an option which can be either mounted to a wall or desk, or mounted
on an optional column. Commonly this is used for displaying weight results to a customer in a retail application.
The remote 2nd Display connects to the Courier 7000 terminal using the Mini DIN connection – when
connected, the other connection options (2nd RS232, Ethernet or WiFi/Bluetooth) cannot be also connected.
Wall-Mounted Display
The 2nd display may be mounted directly to a wall using two screws (not included).
1. Use the male end of the 2
nd
display to connect
the Mini DIN on the terminal through the hole on
the terminal mounting bracket.
2. Select appropriate size screws that fit into the
holes at the bottom of the housing. See Figure
B . When mounting to a wall without a solid
backing, use appropriate anchoring hardware.
Figure B. Direct Wall Mount Arrangement
Male end
Hole
100mm/3.9''
Cable tie
139mm/5.5''