ohanadepot.com Fire Pit Table 15
OPERATION
WARNING: DO NOT ATTEMPT TO OPERATE THE APPLIANCE UNTIL YOU HAVE READ AND
UNDERSTAND ALL PRECAUTIONS. FAILURE TO DO SO CAN RESULT IN PROPERTY DAMAGE,
SERIOUS INJURY, OR DEATH.
Before Lighting
The gas fire pit should be thoroughly inspected before each use, and by a qualified service person at least
annually.
If relighting a hot gas fire pit, always wait at least 5 minutes.
Lighting instructions
1. Make sure control knob is in the
"OFF" position.
2. Turn LP cylinder gas valve to fully
open position.
3. Press down control knob and turn it
counter clockwise to the "LOW" position.
4. Push in the gas control knob all the way and hold.
Continue to press the ignition button for 15 seconds.
5. If the burner is not lit, press down the
control knob and turn clockwise to "OFF" position, repeat from step 3 after 5 minutes.
6. When the burner is lit, turn the control knob to the desired heat output position between "LOW" and
"HIGH".
7. Press down and turn the control knob clockwise to "OFF" position to shut down the appliance. Turn off
the cylinder gas valve.
Flame Characteristic
Normally the burner flame is yellow.
If the burner flame is blue and very small, please check the gas cylinder,
as it may be low gas pressure or empty. If there is enough gas in the cylinder,
please contact customer service to change the burner of the gas fire pit.
If flames lift away from burner or backfire happens or produce
thick black smoke, the fire pit should be turned off immediately.
The fire pit should not be operated again until the unit is serviced
and/or repaired by a qualified service technician.
Twist/Remove Button.
Add “AAA” Battery.
