Oh!FX TYPHOON, Инструкция по эксплуатации

Страница: 3 / 8

INSTRUCTION MANUAL
3
1. Load the pipes/tubes with the desired consumable. Each pipe is optimized for a different
type of consumable. Please refer to the below table to determine the suitable pipe for
each purpose. (the suitable tube is the one with the diameter more adjusted to the size
of the consumable, avoiding a big leak of air). You can use a tape band at the edge so
that the consumable doesn’t falls while manipulating the pipe. When willing to shoot rolled
T-shirts, you can attach them with tape or rubber band to achieve a longer distance. If not,
T-shirts will open in the air and fall some closer.
2.
3. Pull back the ring on the quick coupling for pipes (1) with one hand while you insert the
tube to the quick coupling (1) with the other hand. Release the ring when the tube reaches
the bottom. You will hear a “click” confirming that the coupling is correct. Verify that the
tube has been fixed perfectly. Connect the TYPHOON GUN to the air supply to fill up the
air tank (3) connecting the air tube (7) to the air input (2) and to the source of air. The air
source may be an air compressor or a bottle of CO2 gas with a pressure reducer. We
also suggest a small air compressor with back pack which works with a small battery and
allows you to make about 30 shots without need of electricity.
4. Make sure that the air source does not exceed the maximum pressure admitted for the
TYPHOON GUN (8 BAR/116 PSI).
5. Wait until the pressure gauge (4) of the TYPHOON GUN shows the desired pressure of
work.
6. If you want you can disconnect the air tube (7) of the TYPHOON GUN and make 1 single
shot. If you keep it connected, the TYPHOON GUN will automatically reload the air tank
(3) after shooting. If you have disconnected the air tube, you should re-connect it after the
shot in order to refill the air tank and make a new shot.
7. Hold firmly the TYPHOON GUN with both hands, one holding the air tank (3) and the other
in the butt of the shotgun (6).
8. To shoot, pull the trigger (5) with a quick movement. Once you get used with the machine,
you can reduce the distance range according to your need, by reducing the pressure, or
speed when pulling the trigger.
ASSEMBLY AND OPERATION
Tube TTY2.5 Suitable for rectangular confetti and 10-15m streamers
Tube TTY4.2 Suitable for round confetti 42mm and 5m streamers
Tube TTY5.5 Suitable for round confetti 55mm and confetti shapes
Tube TTY6.3 Suitable for rolled T-shirts