INSTRUCTION MANUAL
4
GENERAL CAUTION FOR 4CLUB MACHINE
• Set a safety perimeter of 3 meters around the machine in which nobody should access at
the moment of the shot.
• Use only the consumables intended for that specific use, and duly certified.
• 4CLUB machine has been designed for the described purpose. Any other use different
from the written will disclaim Oh!FX (CONFETTISHOTS SLU) of all liability and warranty.
• Use only the consumables intended for that specific use, and duly certified.
•
In case of malfunction, do not attempt to disassemble the machine and contact the
distributor or manufacturer. Any manipulation may exclude the warranty
•
Do not wet the machine. To clean it, use a damp cloth and dry it immediately.
• Only one adult and qualified person must manipulate the machine.
REMARKS
• If you keep the machine connected to an air compressor, the machine will get full of air
again in few seconds. Wait until the machine has been reloaded to make your next shot.
(12) select the “CH2” option. The machine will work with the selected main channel
and the consecutive channel.
When working with two DMX channels, the machine will shoot two outputs (output 1
and 2) with the first assigned DMX channel. The other two outputs (output 3 and 4)
will be activated with the consecutive channel assigned.
6.3 – To work with four DMX channels, press the channel grouping button (11).
“CH1”, “CH2” or “CH4” will appear on the screen. Using the forward and backward
buttons (12) select the “CH4” option. The machine will work with the selected main
channel and the three consecutive channels.
When working with four DMX channels, the machine will shoot one single output with
each DMX channel.
7. Shooting.
Important!! To shoot one or several channels, the DMX controller must send out a signal
between 0,1 and 0,5 second without dimerising . In this way, the valve gets automatically
closed and will not make a noise for the loss of air.
