INSTRUCTION MANUAL
3
Placement: Prior you fix the machine, make sure that you have enough height or space around
for the confetti or streamers which will be projected, preventing that they may impact against
people or objects, causing damage.
1.
Place the machine on the floor, fixed on a truss with clamps (not included), or fixed to the
wall by using the wall anchor holes (13).
2.
Connection of the air input (to an air compressor or CO2 bottle):
2.1 – Air compressor: Connect the air tube or hose (14) from the air input (5) to the air
compressor. Turn On the air compressor and check that the pressure is between 6 - 8
Bar (90-120 PSI). Check that there is no air leak.
2.2 – Using a CO2 bottle: Attention! This option is only valid when using CO2 bottle
of Gas, NOT liquid, that is, the bottles without the pipe inside, just as the ones used
for draft beer in a Bar. But remember that you need to reduce the high pressure
contained inside the bottle with a pressure regulator. Connect then the air tube/hose
(14) from this pressure regulator to the air input of the machine (5). Open the CO2
cylinder and check that the pressure is between 6 - 8 Bar (90-120 PSI). Check that
there is no air leak.
3. Current input: Plug the machine with a powercon cable (not included). The power indicator
(8) will then light on indicating the presence of electrical current.
4.
DMX plugging: Plug the DMX cable (3 pin) to the “DMX512 in” input” (6). It also has a
DMX output connector (7). The DMX signal indicator (9) indicates good reception of the
DMX signal. You can then control the 4Club machine from your DMX table. In case you
don’t wish to mix your DMX table with lighting and effects, you can alternativeley use our
DMX pusher console (ref. TC-106) and control up to 8 independent DMX channels.
5. Fix the Output tubes (2) on the machine outputs (1) and orientate to the desired angle or
direction. To do this, loosen the nuts, orientate them and secure the position by tightening
strongly the nuts. Fill up then the tubes with the desired confetti and/or streamers
6.
Channel assignment:
Firstly, assign the main DMX channel with the forward and backward buttons (12).
The 4CLUB machine is able to work with 1, 2 or 4 DMX channels.
6.1 – To work with a single DMX channel, press the channel grouping button (11).
“CH1”, “CH2” or “CH4” will appear on the screen. Using the forward and backward
buttons (12) select the “CH1” option.
When working with a single DMX channel (CH1), the machine will shoot the 4 outputs
at once by activating the assigned DMX channel.
6.2 – To work with two DMX channels, press the channel grouping button (11). “CH1”,
“CH2” or “CH4” will appear on the screen. Using the forward and backward buttons
ASSEMBLY AND OPERATION
