OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ofite.com
9
Timer
The timer can be programmed to turn the heaters on and off throughout the
week. Each set of on/off operations requires setting an ON time and an
OFF time separately. During programming, the following symbol will appear
on the display.
When programming the ON time, the up arrow will blink. When programming
the OFF time, the down arrow will blink.
Setting the Time:
1. Press and hold the “Time Adj” button until a blinking clock appears.
2. Press the “h” and “min” buttons to set the correct time.
3. Press “WRITE” when finished.
Programming:
1. Set the “OUT1” switch to AUTO. Leave the “OUT2” switch off.
2. Set the switch to the right of the display to P1 to activate programming
mode for Output 1.
3. Select the day of the week for each on/off operation, marked by a
dash appearing above the buttons.
4. Press “WRITE” when finished.
5. Repeat steps 3 and 4 for each on/off operation.
6. Set the switch to the right of the display to RUN.
To clear all programmed settings, press and hold the “+1h / CLEAR” button
for 3 seconds.
