7
Officine Gullo
INSTALLATION INSTRUCTIONS
This appliance is Manufactured by OFFICINE GULLO S.r.l
Headquarters and factory
50012 Antella - Bagno a Ripoli (FI) Italy
via della Torricella, 29, - Tel. +39 055
6560324
In the US call (800)-781-7125
Home page http:// www.officinegullousa.com
E-Mail: [email protected]
The manufacturer declines any responsibility for direct or indirect damage caused by
improper or incorrect installation, alterations, maintenance or use of the appliance, as in all
the other cases considered in the items of our sales conditions.
BEFORE YOU BEGIN
The manufacturer declines all responsibility in the event of failure to observe the instructions
given here for installation, maintenance and suitable operation of the product. The
manufacturer further declines all responsibility for injury due to negligence and the warranty
of the unit automatically expires due to improper maintenance and/or installation.
BEFORE YOU BEGIN: It is advisable to test run the oven before installation.
BEFORE STARTING please read this entire document and ensure you are fully conversant
with the require-ments and limitations.
ELECTRICAL INSTALLATION
WARNING:
All electrical work must be performed by a qualified electrician.
Please ensure that the appropriate electrical codes or prevailing local building codes and
ordinances are adhered to.
Ensure that the electricity supply is disconnected at source. Do not use an extension cord
or adapter plug with this appliance.
This appliance must be grounded. Connect to a properly grounded branch circuit, protected
by a 15 amp circuit breaker.
Electrical Supply.
This appliance requires electrical supply – ensure an appropriately qualified person
completes the electrical oven-up. The connection point for the electrical supply is at the
top of the unit, therefore the electrical supply must be run down from the ceiling alongside
the ductwork.
All electrical and venting oven-ups must be in place before commencing installation of the
oven.
The appliance must be connected to an equipotential system. The connection screw is
positioned at the back of the appliance and is identified by the symbol
.
Содержание PVS4EM
Страница 2: ...2 Officine Gullo...
