Officine Gullo
6
ELECTRICAL INSTALLATION
Installation, commissioning and repairs must only be carried out by a qualified and approved service engineer , and
with careful reference to the following instructions:
•
See enclosed wiring diagram
•
The serial number label is set on the rear of the appliance and indicates if the machine can be supplied with
the available tension. The electrical connection must be in accordance with the stated requirements on the data
plate fixed to the rear panel of the appliance.
•
When the appliance is in operation ensure that the voltage does not vary from the fixed value by more then
+/-10%.
•
According to the rules in force the equipment installation must be done by an Omni polar switch between
power grid and equipment with a contacts opening of at least 3 mm. for each pole. The switch must be easily
accessible.
•
Make sure that the appliance is in a perfectly level position by regulating the feet, if necessary.
•
Use
an
appropriate
lagging
by
setting
the
appliance
near
inflammable
walls
and
furniture;
fire
prevention
prescriptions
must
be
followed
very
strictly.
Leave a free space of at least 15 cm from inflammable side walls and back.
•
The equipment installation must be done in the respect of local prescriptions and according to the rules in force.