© Office Star Products December 2011
1
2
3
7
6
10
12
9L
9R
PART
QTY
1.
Base . . . . . . . . . . . . . . . . . . . . . . . 1
2.
Casters . . . . . . . . . . . . . . . . . . . . . 5
3.
Pneumatic Cylinder . . . . . . . . . . . . 1
4.
Height Adjustment Lever . . . . . . . . 1
5.
Synchro Tilt Lever . . . . . . . . . . . . . 1
6.
Mechanism . . . . . . . . . . . . . . . . . . 1
7.
Seat Cushion . . . . . . . . . . . . . . . . . 1
8.
Backrest . . . . . . . . . . . . . . . . . . . . . 1
9.
Arms (9R & 9L) . . . . . . . . . . . . . . . 2
10.
Short Screws . . . . . . . . . . . . . . . .3
11.
Medium Screws . . . . . . . . . . . . . . 4
12.
Long Screws . . . . . . . . . . . . . . . . 6
13.
Back Support (pre-installed) . . . . 1
14.
Allen Wrench (not shown) . . . . . . 1
11
STEP 2
STEP 1
STEP 3
STEP 4
STEP 5
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Attach Heigh Adjustment Lever (4) and Synchro Tilt Lever (5) to Mechanism (6).
STEP 2
Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place.
Insert Pneumatic Cylinder (3) into Base (1).
STEP 3
Attach Arms (9L & 9R) to Seat Cushion (7) using three Long Screws (12) for each Arm (9).
TIGHTEN ALL SCREWS COMPLETELY USING ALLEN
WRENCH (14).
Attach Mechanism (6) to Seat Cushion (7) with the arrow towards the front of the chair using four Medium Screws (11)
TIGHTEN ALL SCREWS COMPLETELY USING ALLEN WRENCH (14).
STEP 4
Attach Back Support (13) to rear of Mechanism (6) using three Short Screws
10),
TIGHTEN ALL SCREWS COMPLETELY
USING ALLEN WRENCH (14).
STEP 5
Place the assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
3
13
80885AL
ProGrid BACK MANAGER’S CHAIR
ASSEMBLY INSTRUCTIONS
®
8
6
4
5
