5
Power switch
: Press
for 3 seconds to turn the unit on or off.
℃
/
℉
switch: Press
℃
/
℉
button to change the temperature display between Celsius and
Fahrenheit.
Temperature setting button
: Press
before adjusting the temperature. When
pressing it for the first time, the display flashes and shows the setting temperature. After 5
seconds, it shows the measured interior temperature. Press
to increase the setting
temperature and press
to decrease the setting temperature.
2 Display window: 2-digit LED display for each to show setting temperature or actual
interior temperature.
Light button
: Press
to turn on or off. T
he light will be automatically on when
opening the door.
Key lock function: If there is no operation with digital control for 3 minutes, it will be locked
automatically. Press
and
at the same time for 3 seconds to unlock.
Setting The Temperature Controls
When pressing
the temperature setting button “+” or “-“, the system will enter in set up
mode of the upper or lower compartment automatically. The LED display will flash and
show the setting temperature. After 5 seconds, the flash will stop and it will show the actual
measured interior temperature.
Press the button once, the temperature will decrease or increase 1
℃
. After 5 seconds of
not pressing the buttons, the LED figure will stop flashing, then revert back to displaying
the setting temperature of the upper or lower compartment.
After the unit is unplugged, the system will return to its default setting temperature, which
is set by the factory. The default setting temperature is as below:
Upper compartment:
The temperature setting can be adjusted from 12
℃
to 20
℃
.
Lower compartment:
The temperature setting can be adjusted from 5
℃
to 12
℃
.
the temperature difference between upper and lower zones needs to be at least 4°C
Attention
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes
before restarting the unit. If you need to restart before this time delay, the Wine
Cooler/Beverage Cooler will not start. If it is a first time use or longer absence before using,
the temperature will differ between the setting and LED display temperature. After running
for a period, the temperature will revert.
Shelves
To prevent damaging the door gasket, make sure to have the door opened all the way
when pulling shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 out of
the rail compartment; however, this unit is designed with a notch on each side of the shelf
tracks to prevent bottles from falling.
Please refer to the following directions for replacing shelves with a different method.
Type A
If needing to remove shelves, move the shelf towards the gap on both sides and align with
shelf support A. Then lift shelf upwards and pull from the cabinet, once the shelf support
has disengaged from the gap.
