3
Operating Instructions and Parts Manual
27208
6/18
2018 OEMTOOLS
™
MASTER FREEZE PLUG KIT
32. We believe the information contained herein to be reliable.
However, general technical information is given by us without
charge and the user shall employ such information at their
own discretion and risk. We assume no responsibility for
results or damages incurred from the use of such information
in whole or in part. Always refer to specific instructions and
technical information supplied by vehicle manufacturer.
NOTE:
The manufacturer declines any and all
responsibility for damage to vehicles or components if
said damage is the result of unskillful handling by the
operator or of failure to observe the basic safety rules set
forth in the instruction manual.
WARNING
:
Read Rules for Safe Operation and
Instructions carefully.
IMPORTANT SAFETY INSTRUCTIONS
The warnings, precautions, and instructions discussed
in this manual cannot cover all possible conditions
and situations that may occur. The operator must
understand that common sense and caution are factors
which cannot be built into this product but must be
supplied by the operator.
DISPOSAL
At the end of the useful life of the product, dispose
of the components according to all state, federal and
local regulations.
PRODUCT DESCRIPTION
The OEMTOOLS
™
27208 Master Freeze Plug Kit is
designed to install freeze plugs on liquid-cooled gas and
diesel engines.
PRODUCT SPECIFICATIONS
Product Dimensions:
28" x 4" x 2.2"
Driver Shafts Included: 8" Straight, 18" Angled
Head Adapters:
3/4", 1", 1-1/4", 1-1/2", 1-3/4"
Adapter Angle: Adjustable
Item Weight:
5.3 Lbs.
CONTENTS
8 In. Shaft (1), 18 In. Angled Shaft (1), Head Adapters (5),
Knurled Ring Nut End (1), Blow-Mold Case (1)
and Instruction Manual (1)
OPERATION
WARNING
:
ALLOW THE ENGINE TO COOL PRIOR
TO PERFORMING ENGINE SERVICE.
1. Select the appropriate adapter for the freeze plug.
NOTE:
Pressure should be applied to the outer edges of
the freeze plug during installation.
2. Slide the retaining ring over the back end of the chosen
driver and hold the adapter onto the ball end. Tighten
the adapter into place at the desired angle.
3. Apply a sealant to the edges of the freeze plug.
NOTE:
Refer to the manufacturer’s maintenance manual
for vehicle specific information.
4. With the freeze plug in place on the engine block, place
the adapter over the plug. Lightly hammer the back end
of the driver until the freeze plug is fully inserted.
NOTE:
The top of the freeze plug should be situated just
below the surface of the engine block. The freeze plug
should be level across.
PRODUCT LAYOUT
Figure Description
Qty.
A
18" Angled Shaft
1
B
8" Shaft
1
C
3/4" Head Adapter
1
D
1" Head Adapter
1
E
1-1/4" Head Adapter
1
F
1-1/2" Head Adapter
1
G
1-3/4" Head Adapter
1
H
Knurled Ring Nut
1
PARTS LIST
NOTE:
Not all components of the product are
replacement items but are illustrated as a convenient
reference for location and position in the assembly
sequence.
OEMTOOLS
™
and/or its distributors have provided the
parts list and assembly diagram as a reference only.
Neither OEMTOOLS
™
nor its distributors make any
representation or warranty of any kind to the buyer and/
or user of this tool that he or she is qualified to do any
repairs or replace any parts of this product. OEMTOOLS
™
and its distributors expressly state that all repairs or parts
replacement should be done by certified or licensed
technicians. The buyer assumes all risk and liability
arising out of his or her repairs or parts replacement to
the original production.
A
B
C
D
E
F
G
H