5
Operating Instructions and Parts Manual
25245
NO CONTACT INFRARED
THERMOMETER
10/18
2018 OEMTOOLS
™
Emissive:
Most organic materials and painted or oxidized
surfaces have an emissive of 0.95 (pre-set in the unit).
Inaccurate readings will result from measuring shiny
or polished metal surfaces. To compensate, cover the
target surface with masking tape or flat black paint.
Measure the tape or painted surface when the tape
or painted surface reach the same temperature as the
material underneath.
Operating:
1.
Operating the unit:
1) Make sure the 9 volt battery is inserted correctly.
2) Press the trigger to turn on the unit.
3) Aim at the target surface and pull the trigger,
then temperature will be shown on the LCD.
This unit is equipped with a laser, which is only
used for aiming.
2.
Locating a Hot Spot:
To find a hot spot, aim the thermometer outside
of interest, and then scan across with an up and
down motion until you locate the hot spot.
(Figure Below)
LCD display & buttons:
1.
LCD display:
a. Data hold icon
b. Scanning icon
c. Laser on icon
d. Backlight on icon
e. Battery power icon
f. Temperature unit
g. Temperature reading
2.
Buttons:
1) Trigger: When pressing the trigger, LCD display
reading with SCAN icon. Release the trigger,
display reading with HOLD icon for 7 seconds
(approx). Built-in 7 seconds auto power off
function.
2) Laser on/off button
3) Celsius/Fahrenheit switch button
4) Back light on/off button: When backlight is
on, any operations will activate the backlight for
7 seconds.
Maintenance
1.
Lens Cleaning
Blow off loose particles using clean compressed
air. Gently brush remaining debris away with a
moist cotton swab. The swab may be moistened
with water.
2.
Case cleaning:
Clean the case with a damp sponge/cloth and
mild soap.
NOTE:
1) Do not use solvent to clean plastic lens.
2) Do not submerge the unit in water.
Made In China
