7
Operating Instructions and Parts Manual
24488
20V MAX* LITHIUM-ION
CIRCULAR SAW
11/18
2018 OEMTOOLS
™
plastic parts. They contain chemicals that can damage,
weaken or destroy plastic.
DO NOT abuse power tools. Abusive practices can damage
the tool and the workpiece.
WARNING
DO NOT attempt to modify tools or create accessories. Any
such alteration or modification is misuse and could result in a
hazardous condition leading to possible serious injury. It will
also void the warranty.
NOTE: It has been found that electric tools are subjected to
accelerated wear and possible premature failure when they
are used on fiberglass boats and sports cars, wallboard,
spackling compounds or plaster. The chips and grindings
from these materials are highly abrasive to electric tool parts
such as bearings, brushes, commutators, etc. Consequently,
it is not recommended that this tool be used for extended
work on any fiberglass material, wallboard, spackling
compounds or plaster. During any use on these materials it
is extremely important that the tool is cleaned frequently by
blowing it out with an air jet.
LUBRICATION
All of the bearings in this tool are lubricated with a
sufficient amount of high-grade lubricant for the life of
the unit under normal conditions. Therefore, no further
lubrication is required.
WARNING
Always charge the battery pack indoors in a well-ventilated
area. The charger must never be subjected to wet conditions.
ELECTRICAL WARNING
CHARGING THE BATTERY PACK:
1. Place the charger in a dry location near a 120V/60 Hz
electrical outlet.
2. Plug the charger into the electrical outlet.
3. The green LED light will turn on.
4. Turn the battery pack upside down and slide it onto
the charger.
5. The green LED light will turn off and the red LED light will
begin to flash indicating the battery pack is charging.
6. The red LED light will turn off and the green LED light will
turn on when fully charged.
7. Once the battery pack is fully charged, remove the
charger plug from the power source and remove the
battery pack from the charger.
NOTE: DO NOT charge batteries when the work area
or the battery temperature is at or below 32° F (0° C) or
above 113° F (45° C).
This symbol designates that this tool
is listed with U.S. requirements by ETL
Testing Laboratories, Inc. Conforms to UL
Std. 60745-1 and 60745-2-2.
Intertek
3042597
JD5385
Green
Light
Red Light
Battery on
the Charger Charging Status
ON
OFF
NO
Charger connected to power supply
OFF
FLASHING
YES
Battery charging
ON
OFF
YES
Battery fully charged
OFF
ON
YES
Battery defective or bad contact
ON
ON
YES
Battery too hot or too cold to be charged
A
B
C
D
G
H
I
J
K
L
JJ
II
HH
GG
FF
EE
DD
CC
BB
KK
AA
Z
Y
X
W
V
U
T
S
R
Q
PP
OO
NN
VV
WW
MM
LL
UU
TT
SS
RR
XX
YY
P
O
N
ZZ
M
E
F
A
B
C
D
G
H
I
J
K
L
JJ
II
HH
GG
FF
EE
DD
CC
BB
KK
AA
Z
Y
X
W
V
U
T
S
R
Q
PP
OO
NN
VV
WW
MM
LL
UU
TT
SS
RR
XX
YY
P
O
N
ZZ
M
E
F
Parts Diagram
