Inspection & Maintenance
Annual inspections of approved suspensions in a fixed location should be done once a year. All elements need
to be checked for structural integrity and application specific deployment.
Stand mounting safety precautions
CX Series speakers can generate considerable energy and may move due to its acoustical energy output. Be
conscious of the surfaces on which you place the speaker and make sure to place stands away from the edge
of the stage or stairs.
Some CX Series models are equipped with a 35mm receptacle cup. This allows for pole mounting and
stand mounting. If you are going to use a stand or pole please think about the following advice:
Make sure that stand is rated to handle the weight of the speaker.
Place the stand on a flat surface paying special attention to balance.
Make sure that the stand’s legs are not in a traffic area and that the cables are routed in such a
way as to avoid tripping and knocking over the speaker. Gaffer’s tape, brightly colored
professional wire management devices or carpets will go a long way to ensuring the highest
degree of safety.
Make sure the stand is in good working order before you place the speaker on the stand.
Only place 1 speaker per pole or stand.
Be extremely cautious when wind is present. Place sandbags on the stand legs. Never place a
banner on the stand as it will become a sail and increase the chances of the speaker toppling
over.
Ask for help when deploying a speaker on a stand or pole.
Hearing damage, prolonged exposure to excessive SPL
CX SERIES loudspeakers can get loud enough to cause permanent hearing damage to humans within a
close proximity. Don’t prolong yourself to exposure to any sounds that exceed 90dB.
For technical specifications, block diagrams and other valuable information refer to the appropriate
cut sheet
Operation
1.
Unpack the unit and inspect for any damage
2.
Place the unit in its intended location i.e. on a stand, table or attached to the suspension cables*
(see above)
3.
Using high quality speaker cable (unshielded) terminated in Neutrik NL4 connectors, connect the
speaker to the power amplifier by inserting the male end of the cable into the female jack on the
cabinet. Gently twist the connector until you feel it snap into place.
4.
Gradually raise the system volume until the desired loudness has been achieved.
5.
Enjoy the beautiful sound
