background image

Safety Rules

 

 

 
WARNING:  
 

 
READ ALL INSTRUCTIONS. 

Do not attempt to operate the tool until you read and understand 

all safety precautions and manual instructions. 
 

 
Never use oxygen or combustible gas as a power source for the tool. 

EXPLOSION MAY 

OCCUR. 

Use dry, filtered, lubricated and regulated compressed air only.  

 
 

 
Never use gasoline or other flammable liquids to clean the tool. Vapors in the tool will ignite by 
a spark and cause the tool to explode. 
 

 

 
Do not exceed maximum permissible operating pressure 120 PSI (8 BAR). 
 
 

 

Disconnect the tool from air supply when: loading and unloading, clearing jams, performing 
service or maintenance and non-operation. 

ALWAYS ASSUME THE TOOL IS LOADED!  
 

 

Do not use the tool when changing one driving location to another, involves the use of stairs, 
ladders or scaffolding. 
Do not carry the tool with your finger on the trigger. 
Do not carry the tool by the hose or pull the hose to move the tool. Carry the tool only the 
handle. 

 
Wear eye protection with side shields. 
Wear eye protection where tools are being operated. 

FREE FLIGHT FASTENERS OR DEBRIS WILL CAUSE PERMANENT EYE INJURY. 

Wear hearing protection and hard hats. 

 
 

Never point the tool at yourself or at any other person at all times. 
Never operate the tool while working above others. 

DEATH OR SERIOUS INJURY MAY OCCUR.  

No horseplay! Work safe! 

 
 

Use pressure regulator, filter and oiler. 
Use air supply hose rated for 150 PSIG minimum. 
Do not use a check valve or any other fitting that allows air to remain in the tool. 
 

 
 
 
 
 
 

Содержание 24402









Отзывы: