ODES UTV Desertcross 1000cc-3, Руководство по обслуживанию

Страница: 180 / 230

6.DRIVE TRAIN
6-
11
TIRES AND WHEELS
When the tires are replaced, never install a bias tire with a redial tire. such a combination could
create handling and/or stability problems.
Dot mix tires of different size and/or design on the same axle.
Front and rear tire pairs must be the identical model and manufacturer.
For unidirectional tread pattern, ensure that the tires are installed in the correct direction of rotation.
The radial tires must be installed as a complete set.
In dismantling tires, use special crowbar and rim protection device.
Tire replacement
Use jack to support vehicle and ensure its
no dropping.
Remove the wheels.
After removing the air valve cap, release
the tire pressure by depressing the valve.
Dismount the bead from the rim completely.
Separate the tire from the rim by using a set
of tire levers and rim protectors.
CAUTION
Apply tire lubricant to the new tire bead and the
flange of the rim. But never apply grease, oil or
gasoline to the tire bead because they will
deteriorate the tire.
CAUTION
Mount the new tire on the rim.
When using the tire lever, do not scratch or hit
the sealing portion of the wheel or it may
cause air leakage.
The standard tire fitted on this vehicle is
AT29×8
–15 for the front and AT29×10–15 for
the rear.
The use of tires other than the standard may
cause instability. It is highly recommended to
use the specified tire.
Inspect the sealing portion of the rim for
contamination and distortion before installing
the tire on the rim.