OCULUS Myopia Master Basic, Инструкция по эксплуатации

Страница: 51 / 90

13 Chronology of Different Measuring Processes
46 / 84 Instruction Manual Myopia Master® (G/68100/EN Rev08)
13 Chronology of Different Measuring Processes
The chronology of three different measuring processes is outlined briefly
below.
1 You enter a patient in the patient data management and then
conduct the measurement.
The examination data are automatically saved under the newly
entered patient’s name
(sec. 13.1, page 46) .
2 You start directly with the measuring operation and then
subsequently save the examination under an existing patient’s
name. Alternatively, you can also enter a new patient after
performing the measuring operation
(sec. 13.2, page 47) .
3 You perform a measuring operation without saving the examination
under a patient’s name
(sec. 13.3, page 48) .
13.1 Enter P Measure

Press the button [Patient] in the patient data management.

Create a new patient, as described in sec. 11.1, page 27 .
The newly entered patient appears in the list of patients and is
highlighted in blue.

Start the measuring operation by pressing the [Measure] button.
Press the optional joystick button.

Conduct the measurement (sec. 12, page 33) .
When the measuring operation has been completed, the overview
screen appears
(fig. 12-5, page 37) .
The conducted examinations are automatically saved in the patient
data management.
The saved examinations can be viewed again at any time (sec. 12.4,
page 44) .