▒▓
www.OctiveTech.com
Operating
Instructions
3
CHAPTER 1 INTRODUCTION
1.1 Brief Introduction
Thank you for using the handheld pulse oximeter. The main functions of this device
are to measure SPO2 and PR, visual and audio alarm, sensor off alarm, data storage
and replay etc. Please read the operator’s manual carefully before operating it.
Application range
: The device is used to monitor patient’s arterial oxygen saturation
and pulse rate continuously.
1.2 Safety Information
!
●
The handheld pulse oximeter is to be operated by qualified personnel only.
Before using, carefully read this manual, directions for using of accessory, all
precautions, and all specifications. The user must check that the equipment
functions safely and ensure that it is in proper working condition before being
used.
●
The is intended for use only as an adjunct in patient assessment. It must be
used in conjunction with clinical signs and symptoms.
●
To avoid an electrical hazard, never immerse the unit in any fluid or attempt to
clean it with liquid cleaning agents. Always take out the batteries before
cleaning.
●
If oximeter becomes accidentally wet during use, stop operation of the oximeter
until all affected
components have been cleaned and permitted to dry completely. Contact your
local representative if additional information is required.
●
If any parameters displayed on oximeter is not accurate, adopt the other
methods to diagnosis patient.
●
The medical equipment must be manipulated by personnel who have already
gotten the relative training of operation.
●
For safe and accurate operation, use only recommended accessories. Request
for the special children or infant accessories, when monitoring infant or
▒▓
www.OctiveTech.com
Operating
Instructions
4
children.
●
Do not use the oximeter in the presence of a flammable anesthetic mixture with
air, oxygen or nitrous oxide
●
Alarm must be set up according to different situation of individual patient. Make
sure that audio sound can be activated when alarm occurs
.
●
For proper equipment maintenance, perform the service procedures at the
recommended intervals as described in the manual.
●
Do not use the oximeter during Magnetic Resonance Imaging (MRI) scanning.
Induced current could potentially cause burns. The oximeter may affect the
MRI image, and the MRI unit may affect the accuracy of oximeter measurements.
●
The oximeter can monitor only one patient synchronously.
●
As to the other points for attention, please carefully read the relevant chapter in
this instruction.
1.3 Electromagnetism interference
The oximeter is low power consumption device. It will not interference
surrounding people, device and environment. Nevertheless, if there is strong
electromagnetic interference near the equipment, it may result in harmful
interference, even makes performance inactivate. Therefore, if any the warp of
anticipated effect appears, you should firstly prevent, identify and solve the
adverse electromagnetic interference, then proceed to use the device.
To reduce possible problems caused by electromagnetic interference, we
recommend the following:
1. Interference from adjacent radio or mobile phone.
If the radio is the interference source, install the equipment in other place. If the
mobile phone is the source, make it far away from the equipment.
2. Direct and indirect electrostatic discharge:
Before using equipment, make sure operator and patient who touch the
equipment have no direct or indirect electrostatic power. Damp room is helpful to
remit such problem.
1.4 Conception of Warning, Caution and Note
Warning, Caution and Note
The Warning, Caution and Note in the manual are special information to draw the
operator’s attention.
●
Warning
