Page 8
Copyright© 2011 Octet Matrix Audio
DWA4416-50 Amplifier Placement/Mounting
The “L” or “R” appended to the end of the model number indicates which channel that
amplifier will receive wirelessly from the transmitter. The DW4416-50 wireless amplifiers can
be placed on top of speakers, on any flat, stable surface, or attached to speakers with
provided hook & loop fastening system. Each DW4416-50 wireless amplifier must be located
near a power outlet.
Final Verification & Optimization
You will use the Octet Matrix Audio Setup CD for the final verification and optimization step.
If the transmitter and speakers will be located in different rooms, we recommended that you
temporarily set up the DW4416-50 wireless amplifiers, connected to speakers, near the
DWT4416 transmitter location. Actual speaker location is not important, but they should be
directed towards the transmitter so you can easily hear them while confirming setup and
adjusting the DWT4416 transmitter.
The test tracks on the Octet Matrix Setup CD are:
1)
Introduction
2)
Left-Right Channel Identification
3)
Left-Right channel phase confirmation
4)
Track 5 warning
5)
1 kHz tone, 0 dBFS
Channel & Phase Verification
1)
Set the volume controls on the DWT4416 and DW4416-50 amplifiers to 12:00 (straight
up). Turn or set the volume control on the source, receiver, or amplifier to 9:00 (¼
volume). Make sure that any distance and/or delay settings are disabled or set to the
same value for both the Left & Right channels.
2)
Insert the Octet Matrix Audio set up CD into a CD player, DVD player, or Blu-ray
player. If the CD doesn’t start playing automatically, point the player to track 1 and
then hit play. When the Octet Matrix Audio Setup CD introduction starts, adjust the
source, receiver, or amplifier volume to a comfortable listening level.
3)
Track 2 is a channel identification track and will alternate between spoken “Left
channel” and “Right channel” routed only to the respective channels. Confirm that
“Left channel” is coming from the DW4416-50L and that “Right channel” is coming
from the DW4416-50R.
4)
If the channels are reversed, check the wiring into the DWT4416 transmitter and re-
route the wires if necessary. If the wiring to the transmitter is correct, check all other
system wiring and fix any incorrect channel routing.
