Page 7
Copyright© 2011 Octet Matrix Audio
use wall anchors capable of holding the weight of the component. If you don’t have a stud
finder, mark the desired location and drill a test hole with a drill the same diameter as the
screw body you would use to attach to a stud. If you hit a wood stud, then use the holes and
screw directly into the stud. If you don’t hit wood, drill out the same holes with a drill
diameter specified for your wall anchors and install and screw into the wall anchors.
DWT4416 Transmitter Mounting
If you choose to mount the transmitter, print out this page. Make sure that Page Scaling in
the print settings is set to “none”. If the planned mounting space is tight, use scissors to cut
around the template outline and position the template exactly where the DWT4416
transmitter will be mounted. Use a nail, screw tip, or other sharp object to mark the wall or
other mounting surface by puncturing the paper at the two crosshairs. Fasten screws to a
stud or anchors leaving approximately ” gap between the wall and the bottom of the screw
head.
