8
8. Adjust levelers
a. Adjust all four levelers to make sure the product sits flat on
the floor. For a lower step up height, screw the rear levelers
into the rear stabilizer bracket. Then level the machine using
the front levelers.
b. Tighten the leveler nut against the frame for each leveler.
Note:
If you move your Q35, you may need to adjust the
levelers to make sure your product is level with the
floor.
If the unit is not level, it may not function
properly.
7. install access panel
a. Position the access panel (D) by sliding the round ends around
the handlebar connections and the top edge under the top
cover and into the recess of the mast boot (I).
b. Press the access panel firmly into place and secure it to the
frame on the left and right sides using 2 Phillips screws (L).
