SPORTS SERIES
DOCKLIGHT
.
INSTALL & OPERATION MANUAL
15
4
Operation / Maintenance
4.1 DUAL COLOUR OPERATION
1. Single colour white
– this mode is entered when the light is first turned on.
2. Single colour blue
3. Fade - Fade between white and blue.
4. Dual colour (blue and white both on)
To cycle between the above modes, turn off the light for less than 1 second, then back on again.
NOTE
: Fade mode is not guaranteed to stay in sync between lights over time.
4.2 SPORT DUAL COLOUR CONFIGURATION MODE
Enables selection of either white or blue colour as default at power up.
To enter configuration mode:
1. Turn on light(s)
2. Wait around 1 second (or until light(s) illuminate)
3. Turn off light(s)
4. Wait for a minimum of 5 seconds then turn light(s) back on again.
5. Repeat steps 2-4 another 4 times. (If the light changes mode on re power up then the light has not been
turned off for long enough in step 4)
6. On the 5th power up, the light(s) should enter the configuration mode
– this will be confirmed with a
sequence of five blue/white flashes followed by a steady white (the steady colour indicates the default
start up colour).
Setting the default start up colour:
1. Once the configuration mode has been entered (see above). Toggling off the power and back on again quickly
(as in a normal mode change) will toggle between the default start-up colours (blue & white). This is indicated
by the colour displayed after the blue/white flash sequence.
2. To save the selected state simply turn off the light(s) when the required start up colour is displayed and wait
for 5-10 seconds.
3. The light(s) should now be configured to start with the selected colour as default
