Oceanic DataMax Pro, Руководство пользователя

Страница: 54 / 80

50
• Using a small philips screwdriver, remove the screw that secures the metal 'negative'
contact strip to the portion of the case that shows the negative (-) symbol. DO NOT loosen
or remove any other screws.
• Carefully lift that end of the contact strip just enough to slide one battery at a time out of
the center of the case.
• Discard the batteries in a proper receptacle.
• Carefully slide one new battery at a time into the center cavity of the case.
• Place the batteries on top of each other oriented so both positive sides face the positive side
of the case.
• Lower the contact strip into place and secure with the scre removed. DO NOT attempt to
use any other type of screw as a substitute.
Installing the battery case in the DataMax Pro:
• Orient the assembled battery case so that you are holding it between your 'right' thumb
and forefinger with the negative side facing up. Ensure the angled corner is on the left
(thumb) side.
• Place the angled-corner end of the battery case up against the contacts located in the
battery compartment.
• Carefully lower the back end of the battery case into the compartment.
Cleaning and lubricating the o-ring:
• Remove the o-ring by placing thumbs at the 3 and 9 o’clock positions on the face of the o-
ring. DO NOT use tools to remove.
• Press both thumbs toward the 12 o’clock position creating a slight bulge in the o-ring.
• Grasp the bulge and lift the o-ring out of the recessed groove.
• Closely examine the o-ring groove of the caseback for any signs of damage that may impair
proper sealing. If found, return your DataMax Pro to your Authorized Oceanic Dealer and
DO NOT attempt to use it until it has received factory service.
• Lightly lubricate the o-ring with silicone grease spreading it thoroughly between your
thumb and forefinger. Wipe off any excess lubricant.
Fig. 35 – Battery Case
Installation
N
_
N
_
Remove this screw 'only'