Ocean Signal rescueME PLB3, Руководство пользователя

Страница: 22 / 28

PLB3 USER MANUAL
22 912S-03718 v01.00 14/11/2022
6. BEACON CONFIGURATION
6.1 Pre-configured Beacons
PLB3s are supplied to the user already configured. The configuration details will be clearly marked
on the product labels and the packaging. In all cases the user must register the PLB3 with the rele-
vant National Authority using the information supplied on these labels.
Configuration Details
Beacon unique Identification Number
Country for which the beacon is programmed
Cospas-Sarsat TAC Number
RLS On (Enabled) / Off (Disabled)
AIS self identification number
Unit Serial Number
Battery Expiry Date
7. APPENDIX
7.1 Maintenance and Troubleshooting
Your PLB3 will require little maintenance except periodic cleaning, if required. Always use a damp
cloth to clean the case and dry thoroughly.
!
Do not use solvents or other cleaning fluids as this may cause the plastics to deteriorate.
! Ensure the antenna is free to unwind.
!
Should the PLB3 turn on during cleaning, make sure it is turned off as quickly as
possible by pressing and holding the TEST/OFF Key until the LED flashes red twice and
release.
7.2 Batteries
The PLB3 contains Lithium iron batteries for long operating life. The battery must be replaced either
prior to the expiry date shown on the rear label or after the PLB3 has been used, even if only activated
for a short period of time. The battery condition can be determined by carrying out the Self Test
procedure shown in section 3 of this manual.
! Battery replacement must be carried out at an Ocean Signal authorised battery replace-
ment centre using manufacturer supplied battery components.
!
DO NOT ATTEMPT TO REPLACE THE BATTERIES YOURSELF
The PLB3 is a life saving device and unauthorised opening and battery replacement may
cause the unit to fail upon activation putting your life at risk.
!
Store between -30°C (-22ºF) to +70°C (+158ºF)
!
Do not short circuit, incinerate or recharge.