Ocean Optics FOS-2x2-TTL, Инструкция по установке и эксплуатации

Страница: 10 / 20

1: Setup
Unpacking the FOS Unit
►
Procedure
1. Unpack your instrument carefully.
2. Inspect the outside of the instrument and make sure that there is no damage. Do not use the
instrument if damage is present. Contact your dealer for repair or replacement information, if
necessary.
3. Use this instrument in a clean laboratory environment.
Contents
Your package should contain the following:
FOS-2x2-TTL unit
One IC-DB15-2 interface cable for switch operation
Setup
Refer to Figures 1 and 2 when setting up your FOS unit.
►
Procedure
To set up your FOS unit,
1. Plug the power supply into the main connection.
2. Plug the connector of the power supply into the sleeve (1) of FOS.
3. Remove the caps of SMA-connectors (2).
4. Connect the SMA connectors of your fibers to the SMA plugs.
5. Plug in your SUB-D 15-pol. connector-in sleeve (3) for automatic TTL-operation (cable
included).
2
000-10000-040-02-0505