①
IR In: Connect the supplied IR Receiver cable for IR signal transmission. Place the IR blaster in direct
line-of-sight of the equipment to be controlled.
②
IR Out: Connect the supplied IR Emitter cable for IR signal transmission. Place the IR blaster in direct
line of sight of the equipment to be controlled.
③
RS-232: Connect a PC or laptop with phoenix terminal for the transmission of RS232 commands.
④
Factory use only.
⑤
EDID: DIP switches 1 and 2 are for EDID setting adjustments. DIP Switches 3 and 4 are for RS-232
ID settings.
ID: Through a 4 PIN DIP Switch, Set the ID number on the 3rd and 4th bits. Upper means 0, Lower
means 1.
⑥
RESET: press and release for EDID setting; press and hold power to reset the product.
Operating Instruction
OPERATION CONTROLS AND FUNCTIONS
Front Panel:
①
DC/24V: Plug the 24V DC power supply into the unit and connect adaptor to an AC outlet
②
HDBaseT Out: Connect to the receiver with a single CAT5e/6/7 cable
③
HDMI Out1: Connect to a HDMI equipped TV/Monitor
④
HDMI Out2: Connect to a HDMI equipped TV/Monitor
⑤
HDMI Out3: Connect to a HDMI equipped TV/Monitor
⑥
HDBaseT In: Connect to the transmitter with a single CAT5e/6/7 cable
Rear Panel
1
2
3
4
5
6
1
2
3
4 5 6
