32
For Wireless Network Users
h
Press
or
to
choose
TKIP
or
AES
for
Encryption Type?
and press
OK
.
Enter the Pre-Shared Key (WPA/WPA2-PSK)
password you wrote down in step
page 30 using the dial pad to choose each
letter or number.
For example, to enter the letter
a
, press the
2
key on the dial pad once. To enter the number
3
, press the
3
key on the dial pad seven times.
The letters appear in this order: lower case,
upper case and then numbers.
(For more information, see
Press
OK
when you have entered all the
characters, then press
1
for
Yes
to apply your
settings. Go to step
.
i
Enter the user name and press
OK
. You can
use
or
to move the cursor. For example,
to enter the letter
a
, press the
2
key on the dial
pad once.
Enter the password and press
OK
, and then
press
1
to apply your settings. Go to step
(For more information, see
j
Press
or
to
choose
TKIP
or
AES
for
Encryption Type?
and press
OK
.
Enter the user name and press
OK
. You can
use
or
to move the cursor. For example,
to enter the letter
a
, press the
2
key on the dial
pad once.
Enter the password and press
OK
, and then
press
1
to apply your settings. Go to step
(For more information, see
k
Your machine will now try to connect to your
wireless network using the information you
have entered. If successful,
Connected
will
appear briefly on the LCD.
If your machine does not successfully connect
to your network, verify your network settings
collected in step
on page 30, then repeat
steps
to make sure you have entered the
correct information.
If your access point does not have DHCP
enabled you will need to manually configure
the IP address, subnet mask and gateway of
the machine to suit your network. See the
Network User’s Guide
for details.
To install Multi-Function Suite or Océ,
continue to step
For Windows
®
Users:
Now go to
For Macintosh Users:
Now go to
Wireless setup is now complete. A four
level indicator at the top of your
machine’s LCD will show the wireless
signal strength of your access point or
router.
