Oce VarioPrint 6000 MICR series, Руководство пользователя

Страница: 8 / 32

Installation
Warning
• Ensure that the machine is placed on a level, horizontal surface of sufficient strength.
• Do not place this machine on an unstable or tilted bench.
• Do not place this machine in a location that is subject to lots of vibrations and shocks.
• Do not use flammable sprays, liquids, or gases near this product, since this could cause
a fire.
Note
• It is recommended that you connect only those copy-control products (or other
products) which meet the (inter)national product safety and radio frequency interfer-
ence standards. Only use an attachment cable as specified by the manufacturer.
Ventilation
• The machine can produce odors of exhaust air when you:
- use this machine in a poorly ventilated room for a long time
- produce large amounts of copies or print
Therefore, make sure that you ventilate this room well.
• Do not block the machine's ventilation openings.
• Do not place the machine in rooms which are too small and insufficiently ventilated.
See the Product Safety Data Sheet of the machine for the ventilation requirements.
• Be sure to allow a clearance of 300 mm/11.81 inch or more at the back of this machine
for the ventilation duct.
Solving Problems
Warning
• When a piece of metal, water or any other similar foreign matter gets inside the ma-
chine, immediately turn OFF the power switch and unplug the power cord from the
power outlet. Then call your authorized service representative.
• Stop using the machine immediately if it becomes excessively hot, emits smoke, or
produces unusual odors or noises. Turn OFF the power switch immediately and unplug
the power cord from the power outlet. Then call your authorized service representative.
Caution
• Stop using the machine if it is dropped or a cover is damaged. Turn OFF the power
switch immediately and unplug the power cord from the power outlet. Then call your
authorized service representative.
• Some areas inside the machine may become hot. Touching these areas could cause
burns. When you check for malfunctions inside the machine such as a paper misfeed,
do not touch the locations which are labeled "Caution HOT". You can find these labels
around the fusing unit, for example.
Chapter 1 - Safety information 8
Instructions for safe use