Océ ProCut Site Prep
Introduction
This document contains information that will be helpful to you in determining the final location for
the cutter, transporting the cutter to its final location, and all specifications for power, space, and
environmental conditions required for the Océ ProCut manufactured by Zünd.
Considerations:
Determine where the cutter system will be located. Any and all construction measures must be
completed before the cutter system is installed.
Location of the cutter should not be in close proximity to printers due to the dust and particle
generation from this device.
Mark out the installation location to scale using adhesive tape. See the section "Technical data" for
the exterior measurements.
Ensure that the installation location meets the relevant requirements: - Room size - Subsurface -
Temperature - Cleanliness (free of dust and dirt)
Ensure that there are connections for electricity and compressed air at the installation location and
that these meet the required specifications.
Check whether it is possible to transport the cutter to the installation location. If necessary, arrange
for a forklift or mobile crane to be available on the installation day.
Examine the route to the desired location of the Cutter.
The following guidelines will help you determine the route and final location of your cutter:
•
Ideally, the crates should be transported to the installation location using a forklift truck or
mobile crane. However, you can also transport the crates over short distances using a pallet
jack with long forks. The installation guide contains detailed information (center of gravity,
requirements) about transporting the crates.
•
Determine a route to the installation location. Ensure that this route is as short as possible
and that it is sufficiently wide.
•
Check the route for any obstacles (narrow passages, doors, railings, radiators, steps).
Remove these if required.
•
Be aware of the size and weight of the cutter and be sure the floor of the route can support
the weight of the crates and forklift!
•
This route must be wide and high enough to allow free movement of the cutter crate,
including corners and bends.
•
For crate dimensions, see: section 5 Technical Data
Confirm a delivery/installation date.
•
A well-prepared installation saves time and money for everyone involved!