Oce DFS10, Руководство оператора

Страница: 35 / 90

Making the books 29
Producing the books
This section contains the procedures for making books
automatically and manually.
Automatic operation (on-line mode)
Use this procedure when the DFS10 is in the on-line mode.
1. Select the correct cover supply from the Control Panel of
the DFS10.
2. Program the host machine to deliver the copy sets to the
DFS10.
3. Retrieve the bound books from the Output Tray of the
DFS10.
NOTE: The entire binding process for each copy set takes
about two minutes from the time the copy set enters the
DFS10 until it is available as a bound book in the Output
Tray of the DFS10.
NOTE: When the books exit the DFS10, you can handle
them and browse through them. You should not, however,
allow them to lie open until the glue in the cover spine has
cooled and reached full strength. The recommended cool-
down time depends on the width of the spine and the
number of books. Refer to the book cool-down table in
chapter 7, ”Technical data”.
NOTE: Move the Book Guide to the left. This will allow
you to remove the books without causing damage to the
covers.