1
www.observint.com
ALI-TP3125R_CQ
190903
What you need
To install the camera, you will need:
•
12 Vdc power source. See
Specifications
for requirements
•
Tools and additional fasteners (may be required) for mounting the camera
•
Phillips #2 screwdriver
•
Video and power extension cable
Installation
Before installation:
•
Make sure that the device is in good condition and all the assembly parts are included.
•
Check the specification of the products for the installation environment.
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the
camera.
•
To avoid fire or shock hazard, use only UL listed power supplies. Verify that the power supply will
provide the rated voltage and wattage for the camera. See the
Specifications
section.
During installation:
•
Camera Lens
: Handle the camera carefully to prevent scratching or soiling the lens. If the lens or IR
array shield becomes soiled, clean it only with approved products. See the
Cleaning
section.
•
Power supply
:
Camera drop cable
: The camera drop cable includes two connectors:
—
Video BNC connector
: For transmission of the video signal across a coax (75 Ω) extension
cable to a compatible recorder.
—
Power connector:
The camera can be powered by 12 Vdc (see Specification section for
requirements. When applying 12 Vdc power, observe the power polarity shown in the diagram
below.
Mounting the camera
An ALI-TP3125R camera can be mounted directly to a wall or ceiling, or with a junction box. The surface
should support at least three times the weight of the camera and junction box (if used). The video / power
drop cable from the camera can be routed either through mounting surface or through a cable channel in
the mounting base.
•
Mounting the camera directly to a wall or ceiling
Typical ceiling mounting
NOTE
If mounting the camera on a ceiling, orient the mounting base so that the cable channel is pointing
away from any source of water, dust, and other contaminates.
a.
Using the drill template provided, mark the location of the screws that anchor the mounting
base to the mounting surface. See the note above. If you are routing the drop cable through
mounting surface, also mark the position of the hole for the drop cable.
b.
Drill holes for the screws that anchor the base to the mounting surface. The mounting
hardware provided is appropriate for most surfaces. However, depending on the surface
materials, more appropriate fasteners may be required.
c.
If routing the drop cable through the mounting surface, drill a 5/8” hole in the middle of the
drill template.
d.
Connect the camera drop cable to video and power extension cables as required.
e.
Connect the other end of the video extension cable to a compatible recorder.
ALI-TP3125R 5 MP HD-TVI 65 ft
IR Outdoor Bullet Camera Quick
Installation Guide
This indoor / outdoor security bullet camera includes the following features:
•
5 MP, 2560 × 1944 resolution
•
0.01 Lux @ (F1.2, AGC ON), 0 Lux with IR minimum illumination
•
2.4 mm fixed focal lens
•
Smart IR, up to 65 ft IR distance
•
IP67
Adjustable sun shield
Camera body
Mounting base
Lens
Adjustable
mounting
bracket
ALI-TP3125R camera
Sun shield lock screw
Camera drop cable
Cable
channels
Camera top view with bracket up
Switch
button*
Cap for
switch
cable
12 Vdc power terminals
HD video BNC connector
* Switch Button:
The Switch button is reserved for future feature enhancements
Camera drop cable connectors
What's in the box
•
Camera assembly
•
Mounting hardware
•
Drill template
•
This instruction guide
