2
www.observint.com
NOTE
Drop cable connectors are not waterproof. Seal if needed.
f.
Connect the other end of the power extension cable to a 12 Vdc (observe polarity) power
source.
g.
Verify that video from the camera can be seen on your recorder or monitor.
h.
Route the drop cable through the hole in the mounting surface, or through the cable channel
in the mounting base, then attach the camera assembly to the surface using the appropriate
fasteners.
Camera adjustments
1.
While observing video from the camera, loosen the pan lock nut and tilt lock screw, point the
camera at your surveillance target, and then tighten the nut and screw to hold the camera in
position.
0° ~ 360°
0° ~ 180°
0° ~ 360°
Rotation lock screw
Pan lock nut
Tilt lock
screw
Mounting bracket adjustment
2.
If a rotation adjustment is needed, loosen the rotation lock screw and adjust the camera to adjust
the horizontal alignment of the camera video.
Open the OSD menu through the recorder
You can open the OSD menu through the recorder in either of two ways: 1) using the recorder main console,
and 2) by logging into the recorder remotely.
•
Opening the OSD Menu through the recorder console
To open the OSD menu on the recorder monitor:
a.
Open the recorder Live View screen, and then click inside the screen where the camera video
image is displayed. See below.
b.
Click the
PTZ Control
icon in the Quick Setting Toolbar. The camera Live View window will
expand to full screen and the pop-up window shown below will open.
Menu
icon
c.
In the
PTZ Control
panel pop-up window, click the
Menu
icon on the
Configuration
line.
d.
Drag the PTZ Control window to a position where it doesn’t cover the OSD menu
NOTE
The PTZ Control window direction buttons and the
Iris +
and
Iris
-
keys are used to
navigate the OSD menu and set configuration options in the camera.
•
Opening the OSD Menu through remote login to the recorder
To open the OSD menu during a remote login to the recorder:
a.
After logging into the recorder, open the camera in a single Live View window.
b.
In the PTZ control panel, scroll down the Preset list to
Preset95
, click the entry to highlight
it, and then click the
Call
icon. See below. The OSD
MAIN MENU
screen will open.
PTZ control panel
Preset95
Call
icon
NOTE
The PTZ control panel direction buttons and the
Iris +
and
Iris -
keys are used to navigate the OSD
menu and set configuration options in the camera.
OSD menu navigation
For the ALIBI Recorder
: Navigation and settings in the OSD are made through direction keys and the
Iris
+
and
Iris -
buttons in the recorder PTZ Control panel. See below.
© 2019 Observint Technologies. All rights reserved.
