Objet Geometries Ltd Eden330\333 User Manual
4 - 5
1.2.3 Preparing the Machine for a Prolonged Pause
It is sometimes necessary to leave the machine for several hours or possibly days
(weekend). The following describes the procedure to be followed when preparing
the machine for such a prolonged pause. This is not closing down the machine as
detailed above.
1. Ensure that the Objet Studio
program in the Host computer is idle (not
in printing mode).
2. Click the Options pull-down-menu, and select the Shut Down option.
3. The system will empty existing material in printing heads, reduce heads
heating, and perform wiping. Please note that this sequence will take
about 5 minutes.
5. Do NOT turn off the machine or the EDEN330\333 software.
1.2.4 Procedure for Restarting the Machine after a Pause
1. Check that there is sufficient material in the cartridges (see Loading and
Replacing Material Cartridges).
2. Click the Options pull-down-menu, and select the Pattern Test option.
3. The system will prompt the user to continue with this sequence, or abort
the selected option. Press [OK] to continue.
4. Once the Pattern Test sequence has been completed, and presented
satisfying nozzles status - One may proceed with printing from the Host
computer.
1.2.5 Procedure for cleaning or replacing the Wiper Blade
The wiper blade installed in the Eden330\333 requires an easy cleaning by
the user, as part of the routine maintenance procedure. This wiper blade can
be also easily replaced if required.
1. For cleaning or replacing the wiper blade, click the
Options
pull-down-
menu, and select the
Clean Wiper
option.
2. The system will raise the wiper blade and prompt the user to replace or
clean the wiper blade.
Created by Neevia Personal Converter trial version
http://www.neevia.com
