OBH Nordica active 1725, Инструкция по эксплуатации

Страница: 65 / 76

65
• Press the [U] or [D] button to see the saved lap times.
• Hold the [M] button for 2 seconds to exit the Recall Lap Times mode and come back
to the counting display. If NO keystroke has been activated for 1 minute, the watch will
automatically come back to the counting display.
• The lap times history is emptied when the stopwatch is reset.
How to reset the stopwatch
• Press the [U] to stop the counting.
• Hold the [D] button for 2 seconds to reset the display to ‘all zero’ again.
How to go back to current time mode
• Press the [M] button 2 times in stopwatch mode to go back to the current time mode.
5. Countdown timer mode
Press the [M] button 2 times in the current time mode
to get to the countdown timer mode.
How to set the timer
• Hold the [M] button for 2 seconds until ‘Hour’ starts
flashing.
• As shown in the diagram, press [M] button to move
between the settings (‘Hour’, ‘Minute’, ‘Second’).
• Press the [U] or [D] button to set the value of the
flashing setting (hold the buttons to change set
value at a higher speed).
• Hold the [M] button for 2 seconds to save your
setting and exit the setting sequence. If NO key-
stroke has been activated for 1 minute, the watch
will automatically exit the setting sequence.
How to use the timer
• Press the [U] button to start the countdown.
• Press the [U] button again to stop the countdown.
• During the countdown, the watch will beep once per minute the last 10 minutes, beep
once per second the last 5 seconds, and emit one long beep when reaching zero.
• The timer will automatically go back to the preset value when the long beep is finished.
64
3. Daily alarm mode
How to set the alarm and turn it ON or OFF
• Hold the [U] button for 2 seconds in the Current
Time Mode until ‘Hour’ starts flashing.
• As shown in the diagram, press the [M] button to
select between the flashing settings (‘Hour’, ‘Minute’,
ON/OFF).
• Press the [U] or [D] button to set the value of the
flashing setting (hold the buttons to change set
value at a higher speed).
• Daily alarm is turned ON when ‘ ’ is displayed.
• Hold the [M] button for 2 seconds to save your
settings and exit the setting sequence. If NO key-
stroke has been activated for 1 minute, the watch
will automatically exit the setting sequence.
• If daily alarm is activated, the watch will beep for
30 seconds on the set time. You can stop the beeping by pressing any button.
• As long as the daily alarm is activated, the watch will beep every day at the set time.
4. Stopwatch mode
Press the [M] button 1 time in the current time mode to get to
the stopwatch mode.
How to measure elapsed ti me
• Press the [U] button in ‘all zero’ display to start the counting.
• Press the [U] button again to stop the counting.
How to get a lap time
• While the watch is counting, press the [D] button to select
the Lap Time Display.
• The watch will automatically come back to the Counting
Display after 10s.
How to recall lap times
• While the watch is stopped or when it is counting, hold the
[M] button for 2 seconds until you get to the Recall Lap
Times mode. You can only perform this action when ‘LAP’
is not flashing.