OBH Nordica 7904, Инструкция по эксплуатации

Страница: 25 / 32

24
25
OBH Nordica Kettle
Before use
Before you use the kettle for the first time, please read the instruction manual carefully and
save it for later use.
How to use the kettle
By pressing the button, marked with a cup, on the handle you can see the amount of water in
the kettle. Press the button until “Lo L” is displayed. Pour water into the kettle – the amount
of water is shown with intervals of 0.25 l in the display. Close the lid. Do not add water when
the kettle is positioned on the base. The water used for the first couple of boilings must not
be used as the kettle may have small impurities from the production.
NOTe: The kettle is equipped with a hinged, lockable safety lid that reduces the risk of scald
considerably as the lid will not fall off if the kettle should overturn. The lid opens by pressing
the locking device (situated at the top of the lid). Always remember to properly press the lid
into place after filling.
The maximum amount of water to be filled into the kettle is 1.7 l. If there is not enough or too
much water in the kettle, it will not work and you will hear a beep and the indicator lamp in
the on/off
button will go out.
The kettle consists of two parts: The kettle itself and a separate, conductive base on which
the kettle can be placed in any position. The kettle shall be used
only with the delivered
base. Adapt the length of the cord and wind up any exceeding cord under the base. The cord
should always be as short as possible and must not hang from the edge of the table in order
to be out of children’s reach.
Every time the kettle is removed from the base, the switch will automatically disengage.
This prevents unintended heating, when the kettle is put back on the base. So, if the kettle
has been removed from the base for a short period of time e.g. in order to fill in extra water
– REMEMBER always to switch on the appliance again. Always unplug the kettle when not
in use.
ImpORTANT: Always keep the lid closed when the kettle is used. Otherwise the automatic
steam switch will not work and there will be a risk that boiling water will spurt out of the kettle.
The automatic switch-off function is extremely sensitive in order to react at the right moment.
In case the switch-off function becomes irregular (the kettle turns off too early or too late),
the kettle should be descaled, as scaling could be the reason for the error (see instructions
for descaling).
Be CAReFul: The surface gets very hot during use!!!
Control panel
Display
When the kettle is not positioned on the conductive base or when the plug has not been
inserted in the socket, press one of the buttons in the panel to have the display light. If
there is no light in the display, this indicates that the battery is completely flat and needs
recharging. Please see the section ”
Battery”.