OBaby Retro Minnie, Инструкция по эксплуатации

Страница: 3 / 6

Fitting the Legs
Press
The front and rear legs are a different width. Please be aware that the rear leg is
narrower at the top, than the front leg (fig.7).
Push the front leg a little way into the seat frame tubes at both sides evenly (fig 8 & 9).
Push in the spring buttons (fig.10), continuing to push the legs until the buttons click into
place in the holes (fig.11 & 12).
Repeat this process until each leg is fitted securely.
The fit of the legs in the frame is very tight for added security. Do not force the legs into
position, but apply an even and constant pressure.
Should the highchair need to be taken apart, gently push in the spring buttons and
evenly ease out the leg assemblies.
fig. 7
fig. 10
fig. 8
fig. 11
fig. 9
fig. 12
Fitting the Seat Back
Unclip the press-studs on either side of the Highchair as shown (fig.1).
Slide the curved part of the seat back support bar into the fabric pocket on the seat back,
whilst the highchair is still folded (fig.2 & 3).
Slide the two ends of the seat back support bar into the seat frame tubes (fig.4) and
push in the spring buttons (fig.5). Continue to push the frame together until the buttons
click into place in the holes on the tubes (fig.6).
Secure the seat into position by re-clipping the press-studs onto the frame as shown
(fig.1).
fig. 1
fig. 4
fig. 2
fig. 5
fig. 3
fig. 6
Press
“Click”
“Click”
4
5
www.obaby.co.uk
www.obaby.co.uk