Fitting and Removing the Hood
Adjusting the Hood
fig. 23
fig. 26
fig. 26a
fig. 24
fig. 27
fig. 27a
fig. 25
fig. 28
fig. 28a
Using the Harness
To fit the hood, place the hood on the chassis, inline with the seat unit (fig.23). Line up
the hood catches on the pegs on each side of the chassis and clip into place. (fig.24).
Secure the hood in place using the hook and loop tape (fig.25, 26 & 27).
To remove the hood, unfasten the hook and loop tape (fig.25 & 26), then lift the hood
clips on both sides of the chassis (fig.28).
To open or close the hood, pull or push the hood as shown above. (fig.26a-28a)
fig. 29
fig. 32
fig. 30
fig. 33
fig. 31
fig. 34
fig. A
Press
‘D’ Ring
Waist
Strap
Crotch
Strap
Shoulder
Strap
Clasp
Harness
Positions
Lower
Inner
Inner
Outer
Outer
Outer
Upper
To fasten the harness, insert each waist strap fastener
through the loop on each shoulder strap (fig.29). Then
insert both waist strap fasteners into the clasp on the
crotch strap (fig.30 & 31).
To release the harness, squeeze each of each clips in the
centre of the harness and pull away from the clasp, one at
a time (fig.32).
Adjust the harness length using the buckles on each strap
(fig.33).
‘D’ Ring
The ‘D’ rings highlighted are provided for fitting a separate
harness complying with BS 6684 (fig.34).
When using the safety harness from birth, it may be
necessary to use the lower holes for the shoulder strap and
the inner holes for the waist straps and crotch strap.
Higher holes for the shoulder strap and outer holes for the waist straps and crotch strap
should be used when your child is of a suitable size. (See fig.A)
WARNING:
Always use the crotch strap in combination with
the waist belt
WARNING:
Shoulder Pads must remain fitted at all times when
using the pushchair
8
9
www.obaby.co.uk
www.obaby.co.uk
Содержание Atlas
Страница 7: ......
