Oasis PGN8EBF, Руководство по установке

Страница: 4 / 24

Section 3: Preparation
4
Read these instructions before installing the unit.
1. Inspect the carton and water cooler for evidence of rough handling and concealed
damage. Damage claims should be filed with the carrier.
2. Locate and install plumbing and electrical service, if required, in accordance with
Roughing-in Drawing. See page 3.
Note : The following states require a licensed plumber to install cooler; AR, GA,
MA, MI, OK, RI, SC, SD, TX, VT and WI. CA, KS, MN, NM and OR allow for a
state-registered installer or contractor as well. State and local plumbing codes may
prohibit the use of saddle tapping valves for water line connection in some
applications. All connections must conform to applicable plumbing codes.
3. This drinking water cooler is designed to be operated at a water supply line pressure of
up to 100 psi (690 kPa). A pressure regulator must be installed in front of unit’s water
inlet if water pressure (including any possible pressure spikes) could exceed 100 psi
(690 kPa).
4. Check available power supply against the water cooler data plate to ensure correct
electrical service. This drinking water cooler is intended to be connected to a 20A
minimum ground fault circuit interrupting (GFCI) device to meet UL requirements. The
rear most 1-
3/8” diameter knockout in frame bottom is for an externally located electrical
supply. Make sure knockout hole edge is smooth and free of any burrs. Use of a Heyco
bushing #2184 in knocked out hole is recommended in order to prevent damage to
service cord and to close up excess opening around cord. Route cord so it does not
interfere with ADA space requirements.
Refer to rough-in drawing
for optimal power, water
and waste line locations.