4
7.
Snap the plastic sensor connector onto the plastic base in the
location marked in figure 2. The clip snaps over the rib on
the outside of the base so that the terminals in the plastic
housing are inside the base.
8.
Open the valve again. Now the controller is ready to sense
any water. NOTE: The water supply line should be
connected directly to the leak controller so it will shut the water off as close to the water supply valve as possible.
Maintenance
•
Replace all four AA batteries yearly to ensure proper leak protection. USE
ONLY “AA” SIZE ALKALINE BATTERIES.
•
Replace batteries if the alarm has been sounding for an undetermined length of
time
•
Replace batteries if the low battery alarm is sounding (2 beeps and 2 LED flashes
in succession)
•
Press the manual close button (see figure 3) at the annual battery change to ensure
the valve functions properly.
1.
Make sure water is turned off and line is not under pressure.
2.
Remove door by lifting out drip tray and pressing door latch down forcing the top of the door to lean outward. The
rectangular opening under the drip tray reveals door latch.
3.
Set door aside carefully to avoid scratching it.
4.
See figure 4 for plumbing path. There are three water lines:
•
WHITE: for water supply to the filter and/or float valve
•
BLUE: exits float valve and
returns to supply reservoir water
•
VIOLET/PURPLE (Red may be
used as an alternate): for
product water or reverse
osmosis brine water
5.
Determine where to mount your
filters in the filter compartment and
drill new 1/8” diameter holes if
needed.
CARBON FILTRATION
INSTALLATION
6.
If you wish to connect a second
point-of-use system such as an ice
maker, you can use the purple
(alternatively it will be red) colored
tube already inserted through the
column support. You will need to
replace the elbow on it with a tee as
shown in figure 4.
FILTER INSTALLATION (if applicable)
Figure 2
Figure 3
