Oase ProfiClear Premium TF-XL, Руководство по эксплуатации

Страница: 64 / 444

- EN -
64
4.3 Connecting the control system
The cable harness contains the connection cables of the signal box, the drum motor and the
rinsing pump. These connection cables have to be connected, the EGC box is already connect-
ed.

K
• Connect the three connectors of the cable harness to the control system sockets. Hand-
tighten the union nuts.
– The connections are designed to prevent reverse polarity.
4.4 Connecting the power pack
The power pack is used to supply power to the control system and the drum motor.
•
Always disconnect or establish the plug connection to the control system while no current is
applied. To do so, disconnect the power pack from the power supply.
How to proceed:

L
•
Connect the plug on the control system with the socket on the power pack. Hand-tighten the
union nut.
– The connections are designed to prevent reverse polarity.
4.4.1 Connecting the EGC box

M
Integration of the filter system into the EGC network is optional and not necessary for operation.
(→ Easy Garden Control System (EGC))
The Connection Cable EGC cable is required for connecting the EGC box.
The correct fastening of the plug connector is important for a secure connection and an interfer-
ence-free EGC network.
How to proceed:

N
1. Remove the protection cap from EGC-IN.
2. Fit the plug connector of the ECG connection cable and secure with the two screws (max.
2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
3. Remove the protection cap from EGC-OUT, fit the terminal resistor and secure it with the two
screws (max. 2.0 Nm) or another EGC compatible unit.
– No Connection Cable EGC is connected to EGC-OUT on the last unit in the EGC network.
The terminal resistor has to be fitted to this EGC-OUT so that the EGC network is correctly
terminated.
– The terminal resistor is included in the delivery scope of the InScenio FM-Master EGC or
EGC-Controller.